Arwen Buckle Update #2

Posted by on Oct 15, 2014 in 3D, Art, costumes | No Comments

Had to finagle the design some – my ‘leaves’ were too thin to properly 3D print, so I selected out the leaves and thickened them. I added more posts, and made them all the same height to help with printing.  I pulled out the back of the design a bit too, since the buckle frame was curved inside itself a little, cupping inward from the back. I brought it out to strengthen the frame.

We’ll see if it works this time.

 

belt buckle2

Leave a Reply

Powered by Yahoo! Answers