“Make sure the polys are correctly facing…”

Posted by on May 6, 2014 in 3D, Art, Design | No Comments

One of the costumes I have on my “to-do” list is the “Chase” dress worn by Arwen in the Lord of the Rings movies. A very helpful person has already gone through and done every bit of necessary research I could ever think of.

The belt buckle on the costume is huge and delicate, and I cannot currently cast metal objects.  It seems like a good candidate for a 3D printer item. I used a sketch someone else had made as a basis for modeling the belt buckle in Lightwave.

Starting with this:

ChaseBuckle_Niki

 

After about four hours, I’m here:

ArwenWIPThe bottom-most leaves are slightly asymmetrical, and I’m going to modify the top set of leaf/wings to also be a little asymmetrical as well. I want to capture the feel of something hand made once it’s printed, and not completely perfect. The only thing I want to look exactly symmetrical are the long upper and lower half-loops. The belt buckle will tie on the sides with ribbon.

At the moment, some of the leaves are overlapping on each other, and I’ll have to fix that before exporting as a printable object. I’m also going to tighten the raised ridges on the half loops to make them more distinct. I’m going to have to experiment with the leaf thickness to see if it’ll be strong enough once printed. I may also glue a wire to the back loops to reinforce them if they seem wobbly.

 

Leave a Reply

Powered by Yahoo! Answers